Encore SP201-SA Manual de usuario descargar pdf (Pagina 3)

Provisioning the SP201-SA 2-3

SP201-SA™ Customization and Maintenance Guide

1 Make sure you have followed the hardware installation procedures

in Chapter 1, Installation, to prepare the system for operation.

2 Make sure you have established communication between the

SP201-SA and a user-supplied control console, as described in

Section 1.5, Connecting to the Control Console.

Note: After communication has been established, you will use a

command line interface to initialize the system.

3 Type show banner and press Enter to view the information for the

protocol-conversion software installed in the SP201-SA.

Note: Figure 2-1 shows a banner for ETSI ISDN–R2 signaling.

Table 2-2 describes the information in the banner.

If you need to install the protocol-conversion set, follow the

instructions in Section 8.1, Updating the SP201-SA Software.

4 The next step is to provision the system. Although you received the

SP201-SA hardware and software already configured for your basic

signaling conversion application, you may need to fine-tune the

configuration to meet your specific network and operational

requirements.

In addition to the standard configurations described in the SP201-SA

Installation Guide, there are two levels of customized configuration

for the SP201-SA, addressed in the following sections:

• Section 2.3, System Configuration. This section describes the

commands for configuring parameters whose values are

independent of the protocols used in the SP201-SA.

• Protocol Configuration. Guidelines for configuring the protocols

the SP201-SA uses are described in the following chapters:

- Chapter 3, Configuration of CAS Protocols

- Chapter 4, Configuration of ISDN Protocols

- Chapter 5, Common Non-System Configuration

- Chapter 6, Timeslot and CIC Configuration

1 2 3 4 5 6 7 8 ... 33 34

Sin comentarios

Encore SP201-SA Manual de usuario Pagina 3