Encore SP201-SA Manual de usuario descargar pdf (Pagina 12)

2-12 Chapter 2: Configuration Overview

SP201-SA™ Customization and Maintenance Guide

Note: The config lim command affects the parameters that other

commands present. You must perform the config lim command

before performing any other commands.

3 Use the config framer command to configure each trunk. See

Section 2.3.4, The config framer Command.

4 Use the config alarms command to configure the alarms. See

Section 2.3.5, The config alarms Command.

5 Use the config clocks command to configure clock synchronization.

See Section 2.3.3, The config clocks Command.

2.3.1 The config time Command

You use the config time command to set the system time for the SP201-SA. (To

view the SP201-SA’s current system time, see Section 7.2.4.17, The show time

Command.)

How to Use the config time Command

1 At the user> prompt, type config time and press Enter.

 If the SP201-SA’s system time has not been set before, the

following prompt is displayed.

 Then, in any case, the following prompt is displayed:

Warning! System date/time has not been set!

user> config time

******************************************************************************

****************************** SYSTEM DATE/TIME ******************************

******************************************************************************

System Date and Time = Sat 2000/01/01 00:03:51.058

******************************************************************************

Enter new system date and time (YYYY/MM/DD hh:mm:ss) ==>

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Sin comentarios

Encore SP201-SA Manual de usuario Pagina 12