Encore SP201-SA Manual de usuario descargar pdf (Pagina 7)

SP201-SA™ Installation Guide 7

E Channel Configuration

See the following sections to configure the protocols in your SP201-SA:

E.1 Channel Configuration for DTMF Signaling

• DTMF signaling Section E.1, Channel Configuration for DTMF Signaling

• R1 signaling Section E.2, Channel Configuration for R1 Signaling

• R2 signaling Section E.3, Channel Configuration for R2 Signaling

• N5 signaling Section E.4, Channel Configuration for N5 Signaling

• ETSI ISDN signaling Section E.5, Channel Configuration for ETSI ISDN

• NI2 ISDN signaling Section E.6, Channel Configuration for NI2 ISDN

What the terminal displays What you type What you are configuring

user> config dt all

All DTMF channels

Set 1/1 thru 2/31 out-of-service?

(y or n) : <current=n> n

Placement of channels 1–31 of

trunk 1 and (on the four-port

SP201-SA) channels 1–31 of

trunk 2 into service

DTMF Caller ID/ANI used? (y or n) :

<current=n>

y (or n if caller ID is

not required)

Request for caller

identification

Other modifications? : (y or n) :

<current=n> n

Completion of standard

configuration for DTMF

signaling (If y

ou wish to

configure other parameters for

DTMF signaling, type y. Then

refer to the SP201-SA

Customization and Maintenance

Guide

user>

(DTMF signaling has been

configured.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Encore SP201-SA Manual de usuario Pagina 7