Encore SP201-SA Especificaciones descargar pdf (Pagina 41)

Monitoring and Troubleshooting the SP201-SA Software 7-41

SP201-SA™ Customization and Maintenance Guide

Caution: You can enable trace cas for more than one timeslot,

as shown in the following list of formats for the trace cas

command; however, this is not advised because of the

possibility of losing calls.

If you enable trace cas for more than one timeslot, a warning is

displayed.

Then, if you answer y, the trace is enabled.

Information will be displayed, similar to that shown below.

Note: If you enable trace cas for more than one timeslot, and later

wish to stop the trace, type trace cas off and press Enter.

usage: trace cas [trk:ts] [on/off]

or trace cas [trk:ts] [trk:ts] [on/off]

or trace cas [trk] [on/off]

or trace cas all [on/off]

user> trace cas all on

************************************************************

* WARNING!!! Multi-channel tracing is NOT intended for *

* operational use! Its use in high traffic *

* may cause improper operation and may even *

* cause a program reset. *

************************************************************

Do you wish to continue (y/N) : y

Traces enabled

[2130/08/25 18:57:02]: Command "trace cas all on" completed

15586.1100-slot4-user>

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

Sin comentarios

Encore SP201-SA Especificaciones Pagina 41