Encore ENDSS-R4D8 Manual de usuario descargar pdf (Pagina 43)

ENDSS-R4D8

3.6.3.1 Record Detection Activate

This feature makes the whole setting of motion setup is efficacious and system will log

the motion triggered event even the DVR under the “Time Recording” mode.

Enable: Activates the whole setting of motion setup

Disable: Deactivates the whole setting of motion setup

NOTE Remember to specify the area you would like monitor using the

“Motion Area Setup” screen. Click on a particular channel you would

like to set and then click on Motion Area Setup to define the

particular area you would like to monitor.

3.6.3.2 Motion Mode

Choose any of the following settings to adjust the motion sensitivity parameter:

Sensitive OFF: No sensitivity

Sensitive Low: Low sensitivity level

Sensitive Normal: Normal sensitivity level

Sensitive High: High sensitivity level

Sensitive Highest: The highest sensitivity level

3.6.3.3 Record Time

Set the recording time when the Motion Mode is triggered.

The recording time as 5sec, 10sec, 15sec, 20sec, 25sec, 30sec, 45sec, 60sec, 90sec,

120sec, 150sec or 180sec.

3.6.3.4 Alarm Mode

Select the alarm mode when Motion Mode is triggered.

Mute: No beep whatever motion is detected or not.

Buzzer-Short: Beep shortly by buzzer on main board.

Buzzer-Long: Beep long by buzzer on main board.

Alarm-Short: Short sound coming from the alarm.

Alarm-Long: Prolonged sound coming from the alarm.

3.6.3.5 Alarm Time

The Alarm Time is the duration of the beep and may be set to: “Nonstop”(no stop), 5sec,

10sec, 15sec, 20sec, 25sec, 30sec, 35sec, 40sec, 45sec, 50sec, 55sec or 60sec.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 131 132

Sin comentarios

Encore ENDSS-R4D8 Manual de usuario Pagina 43