Encore ENPWI-G2 Guía de usuario

ENUWI-G2 802.11g Wireless USB 2.0 Adapter User’s Guide

Configuration This is the page where you can change the basic settings of the 802.11g Wireless USB 2.0 Adapter with the minimum amount of effort to im

Preamble: Select Long or Short/Long (auto) Preamble type. Preamble is a sequence of bits transmitted at 1Mbps that allows the PHY circuitry to reach s

Shared Key/Open System Network Key: Choose the encryption way, either in HEX or ASCII formats, and enter the password in the blank space. Key Leng

WPA / WPA2 WPA2 (Wi-Fi Protected Access 2) is the second generation of WPA; providing enterprise and consumer Wi-Fi user with a high level of assuran

Site Survey Available Network The screen shows all the Wireless LAN devices around your Wireless LAN USB Adapter. The information of the wireless devi

Profile Add: Click “Add” to create a new profile, set the related values such as Profile name, SSID, Wireless Mode and Security settings than click ”A

TECHNICAL SPECIFICATIONS General Standards IEEE 802.11g, USB 2.0, 1.1, 1.0 Radio Technology IEEE 802.11b -- DSSS IEEE 802.11g -- OFDM Data Transfer

TABLE OF CONTENTIntroduction ...

INTRODUCTION Congratulations on your purchase of ENCORE 802.11g Wireless USB 2.0 Adapter. This manual helps to get familiar with ENCORE 802.11g Wirele

UNPACKING AND SETUP This chapter provides unpacking and setup information for ENCORE 802.11g Wireless USB 2.0 Adapter. Unpacking Open the box of ENCOR

HARDWARE INSTALLATION LED Indicator LINK The LINK LED lights green when ENCORE 802.11g Wireless USB 2.0 Adapter is connected to a network successfully

SOFTWARE INSTALLATION This section will lead you to install the driver and utility of the 802.11g Wireless USB 2.0 Adapter. There are 2 ways to instal

2. Click “Finish” to finish the installation. 5

3. Plug-in your 802.11g Wireless USB 2.0 Adapter into your computer’s USB port. 4. When start the utility first time, you will see the Wireless Conf

WIRELESS UTILITY SETTING Windows® XP users may use the built-in wireless utility as default. The following instructions are for Service Pack 2 users.